Browse Departments

Losi Aluminum Clamping Wheel Hex Set (2)

Read Reviews
Write a Review
With your purchase, receive at no cost:
This is a pack of two optional Losi Aluminum Clamping Wheel Hexes, and are intended for use with the Losi TEN-SCTE.

This product was added to our catalog on October 11, 2011.

I have used these for over a year. I've tightened them significantly and then used loctite to make sure they wouldn't move. I found they do not strip wheels as easily as the stock, weigh less, and if you have plastic wheel hexes these are an obvious improvement. If you do have problems with cracking simply contact Horizon Hobby. They have the best Customer Service in the industry.
Aaron Kilander
Good product but you really have to be careful not to over tighten them at all. Cracked all 4 initially. They work well once installed properly, but a more durable design would not have been a hard change to make to them. I guess like me, break one set and learn the hard way because I didn't pay attention, then buy another so they sell more of them.
Patrick Littleton
This is a good product, but be very, very careful when tightening the hex screws. I noticed my rears were cracked after one run, but I suspect I overtightened them at installation.

Free Shipping! Restrictions Apply

Low Price: $13.25
In Stock!
Limited Quantities Available.
This item earns up to 13 Customer Reward points Learn More

Manufacturer Info

Browse other products from Losi