Browse Departments

M2C Racing 4mm Inner Front Captured Hinge Pins (2)

[M2C8910]
Read Reviews
(3)
Write a Review
With your purchase, receive at no cost:
This is a set of two optional M2C Racing 4mm Inner Front Captured Hinge Pins, intended for use with the Hot Bodies D8 and D8T 1/8 Vehicles.

These 4mm hinge pins made from hardened 01 Tool Steel, and are threaded on both ends for 3mm nuts. Red Lock Tight is used on the non-lock nut, which is threaded on the front end of the pin. The rear end of the pin uses a standard 3mm lock nut. This design is intended to keep the suspension blocks from spreading during a crash and stripping out the suspension block mounting holes in the bulkhead.

This product was added to our catalog on May 18, 2009.

Scott Wagner
If you are racing the winter series and its cold, the plastic bulkheads are brittle and these help keep everything together during an unexpected crash. Its just smart insurance.
Adam Vink
Verified Owner
These are great! I was having issues with the stock ones coming out, with these being captured I haven't had any issues since. I haven't had any problems with them wearing out early over a gallon through them on the car and they still look great.
Kah Chik Yong
Verified Owner
Weaker than stock. Use stock pins for near 2 months and change to this and break in my 2nd run with it.

Free Shipping! Restrictions Apply

Low Price: $10.75
Special: $10.49
Quantity:
In Stock!
This item earns up to 10 Customer Reward points Learn More

Manufacturer Info

Browse other products from M2C Racing