RPM Pillow Ball Set Screws & Bushing Caps

[RPM80010]
Read Reviews
(2)
Write a Review
With your purchase, receive at no cost:
This is a set of optional RPM Pillow Ball Set Screws & Bushing Caps, and are intended for use with the Traxxas T-Maxx, and E-Maxx, as well as the Associated Monster GT monster trucks. Until now, the only way to replace damaged or worn out pillow ball setscrews and bushing caps was to purchase new pillow balls as well. This was quite costly and frustrating since rarely do the stock pillow balls wear out. These pillow ball set screws and bushing caps were designed to help reduce costs by nearly half and eliminate the need to buy unnecessary parts! These setscrews and bushing caps are direct replacement parts for stock Traxxas Axle Carriers and RPM Oversized Bearing Carriers.

Associated MGT owners: Stock MGT axle carriers have the same geometry as stock Traxxas T/E-Maxx carriers. The only differences between the two are in the thread size of the setscrews and the spacing between the bearings. This package takes care of those differences and allows Associated MGT owners to run RPM T/E-Maxx Oversized Bearing Carriers (#80031, #80032, #80035, & #80038) on their trucks. The small spacer is used between the two bearings in the axle carrier and the new RPM setscrews replace the stock MGT versions.

Tech Notes: RPM Pillow Ball Setscrews and Bushing Caps are packaged in sets (four setscrews, four bushing caps, and two axle spacers) enough to complete two bearing carriers. In order to complete all four corners of a truck, TWO packages must be purchased.

This product was added to our catalog on October 13, 2009.

Jordan
Verified Owner
By carefully reading the instructions All set screws were perfectly installed. RPM wants you to make the initial threads (Tapp) into the carriers so the screws don ever back out and there is no need to tighten. Use the right size driver (1/4" screw driver handle w/hex bit) set the carrier flat on hard surface. Place the set screw over the opening, loosen or back the set screw out untill it slips onto the first thread thread groove then begin to tighten. The bushing caps used for Team Associated trucks fit into the end of the set screw that goes into the carrier. I havn't had any problems again with blown bearings or loosening set screws. Excellent Product!
Robert J.
Verified Owner
I purchased these for my Associated MGT 4.60. I cant give them a perfect review though. The set screws, were almost impossible to install without cross threading. I think I got 2 perfectly out of the 8 to go in straight. I think if they would have made them coarse thread this would have not been a problem. Other than that they seem to be working fine. Also with the MGT, you will need to grind one side flat on the axle pins in order to reinstall your axles correctly due to the bearing spacers required for this truck.

Free Shipping! Restrictions Apply

Low Price: $6.39
Quantity:
In Stock!
This item earns up to 6 Customer Reward points Learn More

Manufacturer Info

Browse other products from RPM