This is an optional 14T extra hard steel clutch bell from Robinson Racing. Precision CNC machined from extremely durable, high carbon automotive grade steel, these clutchbells will last and last.
Note: This clutch bell uses the standard Losi 5x10mm Front/5x13mm Rear, clutch bearing configuration.
This product was added to our catalog on April 4, 2007.
After going through 3 stock Losi clutch bells and way too many clutch bearings in 2 months of racing every weekend— 2 of them the teeth cracked off, one wore out super quickly — i tried out the Robinson version, along with replacing the center diff spur gear to the robinson version at same time — i have not had any problems and very little wear for over 2 months except for one clutch bearing go bad so far. Both gears have slightly wider teeth and the mesh is just butter smooth. No matter how many engine swaps, the mesh just goes right back to perfect. When using the losi bells the bearing fit was not great and the slop created a difficult mesh. The steel Spur is more rotating mass, so not good for engines with weak bottom end.