This is an optional Xtreme Racing Aluminum Wear Guard, and is intended for use with the Team Losi TEN-T, TEN-SCTE and 810. This part is installed on the bottom of the chassis in the rear position to help prevent wear and extend the life of the chassis.
NOTE: Longer screws may be needed.
This product was added to our catalog on January 6, 2011.
Its true that the taper of the screw holes is incorrect, but it was a quck fix in the drill press (I'd give it 5 stars if I didnt have to work on it). It was one of the changes i made to help settle the nose dive jumping of my SCTE 1.0 and i have carried it over to my 2.0. It has taken a beating and is still fine (i'm down to raw aluminum now)... but there are other options out there now with the skid plate made of different material and weight that i'm going to try out.
It does dig a little if you run your SCTE as low as you can (for racing)... so be prepared to make some ride height changes as well.
Screws protrude past the plate they are NOT counter sunk not even flush with the surface. The screws will be the first thing to hit the ground useless piece of aluminum especially if you cant take it off because the screws are all smashed. I even tried modifying to see if I can make the screws sink further but that didn't work. DONOT BUY!!