This is a pack of four Avid RC 3x18mm Titanium Lower Shock Mount Screws. These Titanium Lower Shock Screws are a must have upgrade for your Mugen, Xray, Agama, and Tekno 1/8 scale vehicles. This screw set offers 2 left and 2 right hand threaded screws with a 5.5mm socket head so you only need to grab one wrench when taking your shocks off. As if that wasn't enough already, Avid also included an innovative center-drilled hole for easy docking of your calipers while measuring your shock lengths.
NOTE: Two of these screws are Left Hand Threaded so you screw them in by turning your wrench counter-clockwise. If you place your car on your pit table in front of you and you have the front end facing you, you put the left hand threaded screw in the left arm. If you spin the car around so the rear is facing, you put the left hand threaded screw in the left arm. The reason for this is because the action of the arm going up and down places enough leverage the screw that it can unscrew your shock screw in those vital long mains.
- Machined from billet 6Al-4V Titanium, M3x18
- 2 Left-hand, 2 Right-hand threaded screws per set. Left-hand thread screws are laser marked.
- Center-drilled to locate calipers for precise shock length and droop measurements.
- Use the same 5.5mm hex driver for shock tops and bottom mounts.
- Lose weight and add "bling" over the kit steel screws (2.8g for a set of 4 ).
- 18mm length fits the following cars: Mugen MBX7 and MBX6E ECO, XRAY XB9 and XB808, Agama A8, Tekno EB48, Tekno SCT410
- (4) lower shock mount screws (2 LH, 2 RH)
- (1) AVID mini decal sheet