This is a set of two HUDY 30mm Lightweight 1/8 Droop Gauge Support Blocks. These Lightweight chassis droop gauge support blocks are a “must have” set-up tool for every off-road or truggy racer. The aluminum frame is CNC machined and drilled for super lightweight design and precise dimensions that guarantee accurate & precise down stop measurements.
Proper chassis droop is a critical, but often overlooked set-up adjustment of modern 1/8 scale off-road vehicles. Proper down travel balance from side to side is essential for proper handling, and because of this HUDY has developed and produced the first purposefully-designed droop guage support block set for 1/8 off-road.
Using the support blocks is simple. Remove the tires from the buggy and using a flat Set-up Board place the chassis on the support blocks; place the front support block below the servo saver, and place the rear support block below the rear bulkhead. Using the #107717 Chassis Ride Height & Droop Gauge, measure the droop under the wheel axle hex. Use the down stop screws to alter the suspension droop on each side of the car; the shocks should extend out far enough that they do not limit the suspension arm movement. Ensuring equal and proper suspension droop will allow the car to achieve a proper traction level and weight transfer depending on track conditions. Please refer to your vehicles set-up book to learn more about droop adjustment.
- CNC-machined aluminum
- Drilled for light weight
- Exact size
- Accurate & precise measurements
- Highly recommended for all off-road buggy and truggy racers