Browse Departments

Scorpion Extended Motor Shaft w/6mm End (86mm)

[SCP-HK-4035-6SHAF-XL]
With your purchase, receive at no cost:
This is a Scorpion 42mm Extended Long Shaft with a 6mm End, and is intended for use with Scorpion HK-4035 motors. The Scorpion HK-4035 motors are built with 8mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, Scorpion offers factory replacement shafts for all the HK-4035 series Scorpion Helicopter Motors. These Motor Shaft Kits include an original equipment factory shaft with the setscrew keyways already cut, a new spacer washer, and a set of 2 retaining clips. This way, when a clip goes flying and bounces off the wall while you are trying to install it, never to be found again, you still have another one to use!

The shaft for the HK-4035 series motors measures 8mm in diameter, and is 86mm in long. The pinion end of this shaft is ground down to 6mm to allow the user to install 6mm pinion gears. The shaft kit will also fit other brushless motors that require a 5mm shaft of this length. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.

This product was added to our catalog on November 20, 2009.

$1.99 Flat Rate Shipping!

Low Price: $35.00
Quantity:
In Stock!
This item is eligible for $1.99 flat rate shipping Learn More
This item earns up to 35 VIP Reward Points Learn More

Manufacturer Info

Browse other products from Scorpion